（1） 施工前对壳体进行检查，清除杂物和油污 （2） 涂刷环氧稀浆，涂刷后立即撒少量石英砂，以增加附着力。 （3） 所用铸石板粘结面要保持干净，擦去杂物，以保证粘贴牢固。 （4） 铸石板粘贴方法应采用揉挤法，以保证胶泥饱满。 （5） 铸石板衬砌时，粘结层厚度一般为1-1.5㎝，泥缝宽度3-8㎜，要用橡皮锤敲击四角较高点，以保证平整度，敲击挤出的胶泥要用油灰刀刮平。 （6）工人施工要戴橡胶手套 铸石溜槽安装施工时要从低向高方向砌筑，板和板之间相接处不要出现逆差，先把底板粘好后在砌筑两侧板 (1) inspect the shell before construction, remove debris and oil (2) brushing epoxy slurry, sprinkle a little quartz sand immediately after brushing to increase adhesive force. (3) the binding surface of the cast stone board should be kept clean, and the sundries should be removed so as to make sure the paste is firm. (4) the sticking method of cast slate shall be kneaded and squeezed, so as to ensure the filling of the pile. (5) cast stone lining, adhesive layer thickness of 1-1.5 cm, 3-8 mm to mud seam width, with a rubber hammer four high angle, in order to ensure the smoothness of cement extrusion with a putty knife scraping to knock. (6) the construction workers must wear rubber gloves to the installation and construction of masonry stone chute from low to high direction between the plate and the plate is not deficit, the first base plate after laying on both sides of the board （1） 施工前对壳体进行检查，清除杂物和油污 (1) inspect the shell before construction, remove sundries and oil pollution （2） 涂刷环氧稀浆，涂刷后立即撒少量石英砂，以增加附着力。 (2) brushing the epoxy slurry, then sprinkle a little quartz sand immediately after brushing to increase the adhesive force. （3） 所用铸石板粘结面要保持干净，擦去杂物，以保证粘贴牢固。 (3) the binding surface of the cast stone board should be kept clean, and the sundries should be removed so as to make sure the paste is firm. （4） 铸石板粘贴方法应采用揉挤法，以保证胶泥饱满。 (4) the sticking method of cast slate shall be kneaded and squeezed, so as to ensure the filling of the pile. （5） 铸石板衬砌时，粘结层厚度一般为1-1.5㎝，泥缝宽度3-8㎜，要用橡皮锤敲击四角较高点，以保证平整度，敲击挤出的胶泥要用油灰刀刮平。 (5) cast stone lining, adhesive layer thickness of 1-1.5 cm, 3-8 mm to mud seam width, with a rubber hammer four high angle, in order to ensure the smoothness of cement extrusion with a putty knife scraping to knock.