（1） 施工前对壳体进行检查，清除杂物和油污 （2） 涂刷环氧稀浆，涂刷后立即撒少量石英砂，以增加附着力。（3） 所用铸石板粘结面要保持干净，擦去杂物，以保证粘贴牢固。（4） 铸石板粘贴方法应采用揉挤法，以保证胶泥饱满。（5） 铸石板衬砌时，粘结层厚度一般为1-1.5㎝，泥缝宽度3-8㎜，要用橡皮锤敲击四角较高点，以保证平整度，敲击挤出的胶泥要用油灰刀刮平。（6）工人施工要戴橡胶手套 铸石溜槽安装施工时要从低向高方向砌筑，板和板之间相接处不要出现逆差，先把底板粘好后在砌筑两侧板 (1) inspect the shell before construction, remove debris and oil stains (2) brush epoxy slurry, and sprinkle a small amount of quartz sand immediately after coating to increase adhesion. (3) use the cast slab to keep the surface clean and remove the sundries to ensure the paste is strong. (4) the method of slab paste should be kneaded to ensure full and full. (5) cast slab lining, thickness of adhesive layer is usually 1-1.5 ㎝, mud seam width 3-8 ㎜, with a rubber mallet percussion corners is relatively high, to ensure the smoothness, knock out of cement with a putty knife. (6) when the construction of workers is to be installed in the construction of rubber gloves, the construction of the stone chute shall be built from low to high, and the connection between the plate and the plate shall not be in deficit. First, the floor shall be glued together and the sides shall be built on both sides of the masonry